Pools

    Travertine and paver pool decks

    Travertine and paver pool decks built for Arizona heat: cooler underfoot than concrete, repairable, and installed on a base that survives monsoon drainage.

    Travertine and paver pool decks in Phoenix run roughly $15 to $45 per square foot installed, depending on material and base work. Both stay cooler underfoot than poured concrete and both can be repaired in sections: a poured deck that cracks has to be cut out and patched, and the patch always shows.

    Why not just pour concrete

    Poured concrete is cheaper on day one and it is the reason so many Phoenix pool decks look tired at year twelve. Arizona thermal cycling cracks slabs, and a cracked slab can only be patched, not repaired.

    Pavers and travertine move with the ground instead of fighting it. A settled area gets lifted and re-set. A stained piece gets swapped. The deck can be maintained rather than replaced.

    The part that decides whether it lasts

    Base preparation. Four to six inches of properly compacted aggregate, correct bedding sand, and real edge restraint. Decks that ripple and settle after two summers were almost always installed on inadequate base by someone bidding to a number.

    Drainage is the other half. A pool deck that pitches toward the house instead of away from it will move water into the foundation every monsoon, and no material choice fixes that.

    What's Included

    Pool Decking & Pavers scope

    Travertine, large-format paver, and natural stone decking
    Coping selection and profile detailing
    Proper base preparation and compaction
    Drainage design and grading away from structures
    Edge restraint and joint stabilization
    Integration with existing pool and hardscape

    Typical Investment

    $15 to $45 per square foot installed

    Standard pavers begin around $15/sq ft; travertine typically runs $25 to $45/sq ft installed with proper base. Removal of an existing deck and any drainage correction are additional.

    Common Questions

    Pool Decking & Pavers FAQs

    How much does a travertine pool deck cost in Phoenix?
    Travertine decking prices by area, base condition, and detail. The stone is only part of it: base preparation, drainage correction, the coping profile, and the cut work around a curved pool all carry cost. Standard concrete pavers sit below travertine on material. Demolition of an existing deck and any drainage correction are quoted separately, because until we see the existing slab we cannot know how much of it has to come out.
    Is travertine or paver better for a pool deck in Arizona?
    Travertine stays cooler underfoot and has the more premium look, which is why it dominates high-end Phoenix backyards. Pavers cost less, come in more colours and patterns, and are slightly more forgiving to install on uneven ground. Both outperform poured concrete for heat and repairability. The right answer usually comes down to budget and the architecture of the house.
    Does travertine get hot in Arizona?
    Travertine gets warm, but measurably less so than concrete or dark pavers: its porosity and naturally light colour reduce heat retention. No surface is cool at 115 degrees in direct July sun. Shade placement and colour selection do more for barefoot comfort than material alone, which is why we design shade and decking together.
    How long does a paver pool deck last?
    Twenty-five to fifty years or more when installed on properly compacted base with correct edge restraint. The material almost never fails first. The base does. Decks that ripple, settle, or spread within a few years were installed on insufficient base, which is why we specify four to six inches of compacted aggregate rather than bidding to the thinnest section that will pass.